Service manual

Setting Communications 5-7
Resetting to Default Values
Use this setting to reset the printer’s communication values to the defaults listed at the
beginning of this chapter.
To access this setting, from the Main Menu select Setup, Serial Comm. Then, follow
these steps.
1. Press  or  until you see Reset.
2. Press CHANGE to highlight the reset options.
3. Press  or  to scroll through the reset options.
4. When you see the reset option you need, press ENTER. Press CANCEL to leave the
reset option unchanged.
Note: Selecting "Yes," resets the baud, parity, word length, and stop bit to factory
default.
If you chose yes, to reset the values, press ENTER to verify.
5. Press BACK until you return to the Home/Online screen.
SERIAL COMM
← Reset →
No
ENTER BACK
SERIAL COMM
Reset
← No →
ENTER CANCE
L
SERIAL COMM
Are you sure?
← Yes →
ENTER BACK
SERIAL COMM
← Reset →
No
ENTER BACK