Service manual

Loading Supplies 2-1

LOADING SUPPLIES

This chapter describes how to load:

 a roll of supply

 fan-fold supply

 a roll of tag supply.

There are two types of supplies:

Thermal Direct specially treated thermal supplies that do not use a ribbon for

printing

Thermal Transfer standard supplies that require a ribbon for printing

If you are using thermal direct supplies, do not load a ribbon.

If you switch from black mark to die cut supplies, make sure the printer's supply type is

set correctly. See "Supply Type

" in Chapter 4 for more information. Your System

Administrator can also send the supply setup packet to change the supply type. Refer to

the optional 9906 Packet Reference Manual for more information about sending the

supply setup packet.