Instruction manual

B10. text Appearance of text with bar code. For UPC and EAN only use 0 to 7. For
all others, use 8, except where noted. Options:
0 Default
MaxiCode Mode 0 (obsolete)
QR Code Model 2
1 No check digit or number system
QR Code Model 1
2 MaxiCode Mode 2 (Numeric Postal Code)
QR Code Model 2
3 MaxiCode Mode 3 (Alphanumeric Postal Code)
5 Number system at bottom, no check digit
6 Check digit at bottom, no number system
7 Check digit and number system at bottom
8 No text, bar code only
MaxiCode (autodetect modes 0, 2, or 3), Data Matrix,
GS1 DataBar, and Aztec.
B11. alignment Choose L, R, C, B or E to align the bar code data correctly in the field. B
centers variable width bar codes, which may not allow pad-character
centering (Code 128, Code 39, etc.) E right justifies variable width bar
codes. MaxiCode, Data Matrix, QR Code, GS1 DataBar, and Aztec must
use L.
B12. field rot Field rotation. Field rotation rotates the whole field, not just the characters.
Rotation is affected by the pivot point, which varies depending on how text
is justified. Lower left corner of field is the pivot point. Options:
0 Top of field points to top of supply
(Use for Maxicode)
1 Top of field points to left of supply
2 Top of field points to bottom of supply
3 Top of field points to right of supply
Note: Serial bar codes with an 8-dot narrow element do not automatically
print at 2.5 IPS. Serial bar codes printed at speeds greater than
2.5 IPS may not scan properly.
B13. type Select from the bar code family. This parameter only applies to the GS1
DataBar bar code. For other bar codes, do not include this parameter.
Options:
1 GS1 DataBar 14 (default)
2 GS1 DataBar 14 Truncated
3 GS1 DataBar 14 Stacked
4 GS1 DataBar 14 Stacked Omni directional
5 GS1 DataBar Limited
6 GS1 DataBar Expanded
7 UPCA
8 UPCE
9 EAN13
10 EAN8
11 UCC/EAN128 and CC A/B
12 UCC/EAN128 and CC C
Defining Fields 3-21