Instruction manual

Defining the RFID Setup Packet for HF
This packet is only valid on 9855 RFID printers. Use the RFID setup packet
(X) to set the protocol, write attempts and attenuation.
Note: Refer to the HF Setup Guide and Supply Chart for the protocol and
attenuation settings based on your RFID supplies.
Syntax {I,X,protocol,write_attem,attenuation¦}
X1. X RFID Setup Packet
X2. protocol Select the HF protocol. The default is 0. Options:
0 AUTO-Select
1 TI ISO15693
2 NXP ISO15693
3 I-CODE UID
X3. write_attem The number of times the interrogator tries to program the RFID tag in the
RF Field. The range is 1 – 4. The default is 3.
X4. attenuation The amount of power to read an RFID tag. The range is 1 – 4. The default
is 2.
Example {I,X,0,3,2¦}
Uses the default protocol (AUTO-Select), sets the number of write attempts
to 3 and the attenuation to 2.
2-42 Configuring the Printer