Instruction manual

¨ If you remap your image buffer, make sure the length and width specified
in your format header are not too large for the current image buffer. In
other words, if you remap for a 4 x 4 inch label, you cannot print a 4 x 6
inch label without receiving an error, until you change your format
header or increase your image buffer.
Memory Considerations with Downloaded TrueType Fonts
¨ The size of the TrueType font file, in bytes, is the minimum amount of
memory you must have available in the downloadable fonts buffer.
¨ The scalable (vector) fonts buffer is used to image the downloaded fonts
(TrueType). If you are using several downloaded TrueType fonts, you
may need 100K or more in this buffer. The printer does not print the
fonts if there is not enough memory in the scalable (vector) fonts buffer.
¨ To use large point sizes (greater than 60 point), you must reconfigure
memory and increase the size of the scalable (vector) fonts buffer.
¨ Font storage is limited on the 9825 printer, because there is no extended
memory available.
Formatting Flash Memory
Before you send packets to flash memory, it must be formatted first. This is
required once during initial printer setup. From the Main Menu, select
Setup, Flash Memory, then Format Flash. The process takes a few minutes.
Note: When you format flash memory, all packets (formats, fonts,
graphics, etc.) stored in flash memory are deleted and must be
resent to the printer.
Configuring the Printer 2-31