Instruction manual

Special Considerations When Using Backfeed
Make a note of the following items:
¨ Be careful when tearing supplies, because the adhesive can adhere to
the printhead or platen roller.
¨ Backfeed affects each label in the on-demand mode or the first and last
label of the batch in continuous mode.
¨ When backfeed is enabled and multiple batches are sent, the printer may
not backfeed between each batch.
¨ Backfeed should only be used when you need to advance labels to the
desired dispense point.
¨ Backfeed does not interfere with the supply, print, or margin positions
you have set.
¨ If the supply inter-label gap is not between .07 inch to .15 inch (14 to 30
dots), you must adjust the dispense position and backfeed distance
accordingly.
See the following graphic for a representation of the following adjustments:
dispense position, backfeed distance, supply position, print position, and
margin position.
Contact Technical Support if you have problems adjusting where the format
prints on the supply.
2-24 Configuring the Printer