Instruction manual

Command Parameter
^RB
Repeats the last printed batch, printing the same number of labels as specified in the
original batch. This command does not work if using batch separators.
Note: Printer ignores this command if printing.
^RS
Resynchronizes supply when supply roll is changed.
Note: Printer ignores this command if printing.
^SD or ^SCd
Disables the status polling feature by turning off the status polling control character.
Sets the status polling control character to the ASCII value given by the d parameter.
The value of d can be any ASCII character.
^SFa
Loads script with host response.
^SFb
Loads script without host response.
^SFc
Enables script.
^SFd
Disables script.
^SFe
Uploads script version information.
^SFf
Deletes script.
^SFg
Turns on ENQ status polling before it reaches the script.
^SFh
Turns off ENQ status polling before it reaches the script.
^SFi
Turns on immediate commands before it reaches the script.
^SFj
Turns off immediate commands before it reaches the script.
^TP
Prints a test label.
Note: Printer ignores this command if printing.
^VLC
Only clears the data that has been uploaded, not all the logged data. Data is cleared
with this command after a successful upload. We recommend clearing the log file after
uploading.
^VLD
Disables verifier data logging (default when the printer is reset).
^VLE
Enables verifier data logging.
^VLU
Uploads the log file to the last port that received host data (serial, parallel, USB, or
Ethernet). Repeat this command until data is successfully uploaded. Data can be
cleared after it has been uploaded.
The table represents the defined immediate command control character as ^
and the defined status polling control character as d. You may define these
characters to suit your needs.
Note: To use the immediate command control character or the status
polling character within your data, use the tilde sequence.
2-20 Configuring the Printer