Instruction manual

D4. decimals Number of digits to the right of the decimal. Options:
0 No digits
1 One digit
2 Two digits (default)
3 Three digits
Example {I,D,1,1,2 p }
Prints the dollar sign, uses a secondary symbol, and places two digits to the
right of the decimal.
Defining the Control Characters Packet
Use the control characters packet (E) to change the MPCLII control
characters, enable and disable the immediate commands, and change the
default terminator character for job requests and ENQ’s.
Changes take effect with the first character following the end of header
character } of the configuration packet. Each control character must be
unique and cannot appear anywhere else in your packet, except within
quotation marks. You can customize the trailer characters to work with your
host.
Note: Wait two seconds for the new characters to take effect before
sending packets using the new characters.
If using symbol set 110 (Unicode UTF-8) to print International characters,
set the MPCL control characters (start of header, etc.) to decimal values
between 0 and 128; otherwise, errors may occur with the Unicode data
entered.
Use the following syntax for the control characters packet. Notice all but the
first parameter are within quotation marks.
Configuring the Printer 2-15