Instruction manual

The parameters for each packet (A-M) are displayed. In the first line that
begins with M, 76365 is the total volatile memory available, 45190 is the
memory available in volatile RAM. There is no non-volatile RAM available.
The remaining lines beginning with M list the buffer sizes in 1/10K for the
Receive, Transmit, Image, Downloadable Fonts, Formats, and Scalable
Fonts Buffers.
Configuration Syntax Guidelines
When creating a printer configuration packet:
¨ Follow the “Standard Syntax Guidelines” listed at the beginning of this
manual.
¨ The first character after the start of header ({) is the configuration
header (I).
¨ Download multiple configuration packets within one packet or download
a single configuration packet.
¨ If you change any of the online configuration packets, resend the format
packet to the printer, so the configuration changes take effect.
¨ Include the first five ANSI codes, at a minimum, in the control characters
packet.
¨ Send configuration packets once per session (each time the printer is
turned off and then back on), not with every format or batch packet.
Making Print Adjustments
You can adjust where the printer prints on your supply by adjusting the
supply, print, or margin positions. However, keep in mind the following:
¨ Supply adjustments across the width of your supply, such as the margin
position, are based in dots- either 203 dpi or 300 dpi, depending on your
printhead density.
¨ Supply adjustments for the length of your supply, such as supply position
or print adjustment, are always measured in 1/203 of an inch, regardless
of your printhead density.
2-8 Configuring the Printer