Instruction manual

785 The internal liner take-up reel is full. Remove the liner take-up
reel and dispose of the liner. Press ESCAPE/CLEAR to continue
printing.
790 Wait until the printer is idle (no batch waiting to print or not
receiving data) before you send any packets. This error may
occur when you try to print a test label if the printer is busy.
791 The printer has an error pending. Turn off the printer. Wait 15
seconds and turn it back on. Resend the packets. If the problem
continues, call Technical Support.
792 The printer is not initialized. Call Technical Support.
793 The printer job queue is full. Turn off the printer. Wait 15
seconds and turn it back on. Resend the packets. If the problem
continues, call Technical Support.
794 The backfeed mode is not set.
795 Print engine lock-up. Call Technical Support.
Script Errors
These errors occur when there is a script (application) problem.
Error
Code
Description
850 Invalid script packet or not enough flash memory for the script.
The script download failed. Format flash memory and download
the script using the COPY command from DOS or the ADK2
software.
851 Invalid lookup table or not enough flash memory for the script.
The lookup table download failed. Check the data in the lookup
table. Format flash memory and download the script using the
COPY command from DOS or the ADK2 software.
8-24 Diagnostics and Errors