Instruction manual

765
The printhead has less than 8 bad dots. The printer can shift bar
code fields to avoid bad dots. You may need to press
ESCAPE/CLEAR to continue printing. Print a test label to confirm
the number of bad dots.
766 Backfeed/overfeed error. There is a problem with the backfeed or
overfeed distance.
767 Incorrect AD value. Call Technical Support.
768
Printhead has more than 8 bad dots within the format area or is
not connected. Make sure the printhead is connected.
769 The printhead is not receiving enough volts. Call Technical
Support.
770 The print motor is not ready. Call Technical Support.
771 The format specified by the application was not found. Reload
your application and format, and try again. If the problem
continues, call Technical Support.
772 Verifier scan error (bad scan) on label or multiple labels in a row
when using overstrike and continue mode. Press
ESCAPE/CLEAR to clear the error and continue printing.
773 Verifier Failure - the verifier is enabled, but not connected. The
printer can detect if the I/O and/or serial cables are connected to
the verifier. Refer to your verifier’s Operating Instructions for
more information.
781 The voltage is too low. Call Technical Support.
782 The voltage is too high. Call Technical Support.
783 The printer is printing too fast for the verifier to accurately scan
the bar codes. Increase the bar code height in your formats or
slow the print speed.
784 No power to stacker. Check connections between the stacker and
the printer. Make sure the printer is connected to an AC outlet.
Diagnostics and Errors 8-23