Instruction manual

752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754 Printer has a ribbon problem. Check the ribbon for a jam or
remove any slack by turning the take-up reel clockwise. Load a
new ribbon.
755 Printhead is open. Close the printhead before continuing. If the
error persists, call Technical Support.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by plus or
minus .25 inches from the format. Press FEED/CUT to print on
the current supply or load new supply and press ENTER/PAUSE.
758 Check supply. Either the supply is not seen, or the on-demand
sensor is broken (purchase optional). Check for a label jam.
Clear the supply path or reload supplies. This error may occur if
you remove a label too quickly in on-demand mode. The printer
does not recalibrate after this error.
759 Knife is not moving. Call Technical Support.
760 Knife jam. Call Technical Support.
761 The stacker is full or jammed. Empty the stacker or clear the jam
before continuing. The printer does not recalibrate after this error.
762 Low Voltage. For DC-powered printers, recharge the external
battery. For AC-powered printers, check the power inlet where
the printer is connected. The acceptable voltage range is between
90-132 V
RMS
and 180-264 V
RMS
. If more or less power is received,
unpredictable results may occur.
763
Waiting to dispense label. Press FEED/CUT.
764 Verifier scan error (bad scan) on label when using normal (no
overstrike) mode. Press ESCAPE/CLEAR to clear the error and
continue printing. Make sure you did not apply Option 62 (do not
scan a particular bar code) to all bar codes on a format.
8-22 Diagnostics and Errors