Instruction manual

612 The data in this line of the batch is either missing or does not
match the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid character in the
packet. Make sure you did not enter O for Ø.
615 Bar code width is greater than 16 inches or the number of
keywords for your PDF 417 bar code exceeds 928. Decrease the
density or shorten the amount of data to print the bar code.
616 A bad dot falls on a bar code and the dot cannot be shifted. A
gray box is printed instead of the bar code. However, 2D bar
codes still print on the 9825 printer when bad dots are present
within the bar code field.
618
Magnification must be 1 to 7 or 4 to 255 (point size) for the
scalable font.
619 The JIS (16-bit) code for Kanji is invalid.
620 Font and printhead dot density mismatch. A 300 dpi font is
specified in the format, but a 203 dpi printhead is used in the
printer or vice-versa. Check the font or change the printhead to
correct the error.
621 An error occurred opening the TrueType font file. Select a
different font to download. If the error message persists, call
Technical Support.
622 Not enough memory to create the downloaded TrueType
characters in the scalable (vector) fonts buffer. Reconfigure the
printer’s memory and increase the scalable (vector) fonts buffer.
Resend the font, format, and batch packet after reconfiguring the
memory. If the error message persists, call Technical Support.
8-18 Diagnostics and Errors