Instruction manual

Communication Errors
Error
Code
Description
409 The printer memory is full. Delete unnecessary formats or
graphics from memory. If you are using a graphic file that is very
large, consider using another mapping method (such as run length
encoding) to reduce the required memory. To use flash memory,
you must format it first. See “Formatting Flash Memory” in
Chapter 2 for more information.
410 Parity on the printer does not match the parity on the host. Check
the parity setting under SETUP options.
411 Framing error. The printer cannot communicate with the host.
Make sure the host is turned on, communication cables are
connected correctly, port settings are correct, and
communications are active. Check the baud rate, word length,
and stop bits to make sure they match those at the host. Do not
toggle between Microsoftâ Windowsâ and MS-DOS while using
the COPY command, or you will receive a framing error. Exit
Windows before using the COPY command. Re-transmit the
data.
412 There is a problem with flow control between the printer and the
host. Make sure the printer and the host flow control settings
match (both are DTR or both are XON/XOFF). If the error
persists, call Technical Support.
413 Online receive buffer is full. Check your printer’s XON/XOFF or
DTR SETUP values to be sure there is not a flow control problem.
414 The internal keyboard buffer is full or you need a new keypad.
Call Technical Support.
415 The buffer size you defined exceeds the total available in your
machine.
416 Flash/PC board error. Call Technical Support.
Diagnostics and Errors 8-15