Instruction manual

284
The buffer type must be D (Downloadable Fonts), F (Format), I
(Image), R (Receive), T (Transmit), or V (Scalable Fonts).
285 The storage device type in the memory configuration packet must
be F (flash) or R (volatile RAM).
286 The buffer size is invalid.
287
The printhead width must be 0.
288
The battery voltage must be 0 (15-volt battery) or 1 (12-volt
battery).
289 The printer address specified in the communication settings
packet must use exactly six characters.
290
Action must be 0 (disable), 1 (enable), or 2 (extended) for the
backfeed control packet or the printer is active.
291
Dispense position must be 50 to 200 dots or the printer is active.
292
Backfeed distance must be 10 to 200 dots or the printer is active.
The backfeed distance can not be greater than the dispense
position.
293
The skip index selection defined in the field must be 0 (disabled)
or 1 (enabled). Correct the packet and resend to the printer.
294
The verifier mode must be 0 (disable) or 1 (enable).
295
The verifier’s cable detect mode must be 0 (no detect), 1 (I/O
cable detect), or 2 (I/O and data cable detect).
Check Digit Errors
Error
Code
Description
310
Check digit scheme number must be 1 to 10.
311
Modulus must be 2 to11.
Diagnostics and Errors 8-13