Instruction manual

E7. cut_mult Number of tags to print before
cutting. A cut multiple of one cuts
after each tag. Range: 0 to 32,000.
0 is the default.
The cut multiple is a multiple of the
print quantity. If the cut multiple
is three and the print quantity is
16, then five sets of three tags
and one set of one tag is
produced.
Note: The last tag in the batch is
always cut, regardless of the
multiple.
E8. ver_mode Verifier Mode. Enables or disables
the verifier. For more information
about enabling the verifier, refer to
the Verifier’s Operating Instructions.
Not all the printers support a verifier. Options:
0 Disable verifier - not using a verifier (default)
1 Enable verifier
E9. cable_det Verifier cable detect. The printer can be set to detect when a verifier’s
cable is disconnected. For more information about connecting the verifier’s
cables, refer to the Verifier’s Operating Instructions. Options:
0 The printer does not detect when a cable is
disconnected (default)
1 I/O cable is disconnected
2 I/O and/or data cables are disconnected
Example E,0,1,4,2,1,4,1,2 p
Defines a batch control field. Continuous feed mode is used and a
separator prints between batches. Four tags have the same image and
there are two identical parts on one tag. The knife cuts after every four
tags. A verifier is enabled and the printer detects when either the I/O or
data cables are disconnected.
6-6 Printing