Instruction manual

Using Expanded Gen2 Data
With version 5.0 or greater software, we support Expanded C1Gen2 data,
which is composed of five different fields:
EPC Data (64 or 96-bit) Kill Password
User Memory Lock Code
Access Password
The printer also accepts EPC data following the guidelines in the
EPCglobal
Tag Data Standards Specification, which conforms to the
EPC Radio-Frequency Identity Protocols Class 1 Generation 2 UHF RFID
Protocol for Communications at 860-960MHz Standards (RFID Air
Interface protocol). Refer to the EPC Specification to create valid EPC
data.
Many different RFID supplies (tags) are available and the amount of
programmable user memory varies with the chip embedded in the tag.
Depending on your tag type, all memory fields may not be available.
Refer to the RFID Setup Guide & Supply Chart for details about the
available user memory for each chip.
Note: Incrementing an Expanded C1Gen2 RFID Data Field is not
supported.
Use the access password to control when new data can be written to a
field. The kill password sets a tag up to be inoperable. The lock code
contains the locking method.
4-14 Multi-Protocol Application Notes