Instruction manual

Syntax R,5,code¦
R1. R Option Header.
R2. 5 Option 5.
R3. code Input code for the data in the field. Options:
H Host
K Keypad
N No user input for this field
R RFID (read data from the RFID chip). This
is ignored on non-RFID printers.
Note: Option 5 re-images each label in the batch.
Example T,2,10,V,250,50,0,1,1,1,B,C,0,0,0¦
R,5,R¦
Reads the pre-programmed data from the RFID chip and saves that data
into the text field.
Using Option 6 (Upload Field Data)
You can upload data from any field using Option 6. When uploading
multiple fields of data, the data is comma separated.
Data is uploaded to the last port that received host data (serial, parallel,
USB, or Ethernet) at the end of the batch or label, depending on the other
options used as follows:
♦ When using a batch quantity of one without Option 5 or Option 60,
data is uploaded at the end of the batch.
♦ When using a batch quantity greater than one with an Option 5 and/or
Option 60, data is uploaded after each label.
Note: To upload data on a field that did not change, apply Option 60 to
that field.
Syntax R,6,device¦
R1. R Option Header.
R2. 6 Option 6.
R3. device Last port that received host data. Use H (host).
Defining the RFID Data Field 4-5