Instruction manual

Version Information
The RFID version information is included in the Diagnostics Menu. When
prompted for the diagnostics password, press Feed/Cut three times and
then press Enter/Pause.
MAIN MENU
Service Diag
User Diag
RFID
Hardware
RFID
Firmware
1284 Port
Knife
Printer
Version
Diagnostics
1. From the Diagnostics Menu, press  or  until you see
DIAGNOSTICS
Version 
2. Press Enter/Pause.
VERSION
 RFID Hardware 
3. Use  or  to see all the options: Printer, Knife, 1284 Port, RFID
Hardware, or RFID Firmware. After you display the option you want,
press Enter/Pause. A screen similar to this one is displayed:
Model M9855
931110841
The RFID versions are for the antenna/board (hardware) and
firmware. Your version information for Hardware and Firmware
may appear different from the one shown.
You can also display the Firmware and Hardware Versions by
printing an RFID Configuration Label. See Chapter 2, “Multi-
Protocol Encoding,” for more information.
4. Press Escape/Clear until you see the Main Menu.
Setting Up the Printer 3-7