Instruction manual

Note: The printer does not recalibrate (feed a blank label) after any
RFID error.
For more information about the error actions, see the following table.
Error Action
Standard
Peel
Verifier with
Peel
RFID with
Peel
Overstrike/Continue 1-5 No No No
Normal (no overstrike) Yes Yes Yes
Note: If using the Overstrike and Continue error mode, do not use peel
mode.
To change the setting, from the Main Menu, select Setup, then Supply.
Then follow these steps.
1. Press  or  until you see
SUPPLY
 Error Action
2. Press Enter/Pause. The current setting is displayed, for example:
ERROR ACTION
 Ostrk/Cont 1x 
3. Press  or  see the other options. After you display the option you
want, press Enter/Pause.
4. Press Escape/Clear until you see the Main Menu.
Note: Depending on the selected error action, you may or may not see
a label with the overstrike pattern.
Setting Up the Printer 3-5