Instruction manual

Setting the Supply Type
You can print on center
aperture, black mark, die
cut, continuous, or tag
edge aperture supplies.
You have to tell the printer
which supplies you are
using.
If using edge aperture tag
stock containing an RFID
antenna, select Tag Edge
Aperture.
Tag Edge Aperture supply
To change the setting, from
the Main Menu, select Setup, then Supply. If password protection in
enabled, press Feed/Cut three times, then press Enter/Pause before you
see the Setup Menu options. Then, follow these steps.
1. Press » or ¼ until you see
SUPPLY
Supply Type ¼
2. Press Enter/Pause to set the supply type option. The current setting
is displayed, for example:
SUPPLY TYPE
» Black Mark ¼
3. Press » or ¼ to see the other options. After you display the option
you want, press Enter/Pause.
4. Press Escape/Clear until you see the Main Menu.
Setting Up the Printer 3-3