Instruction manual

The following table lists the Supply Menu options.
Option Choices Default Use for RFID
Supply Type Aperture/Die Cut/Black Mark/
Continuous/Tag Edge Aperture
Die Cut Die Cut
Ribbon No/Yes/High Energy Yes Any
Speed 2.5/4.0/6.0/8.0/10.0/Default
Note: The printer pauses while
programming the RFID tag.
Default Any
Feed Mode Continuous/On-Demand Continuous Any
Backfeed Off/On/Extended Off Conditional*
Print Position -450 to 450 0 Conditional*
Supply Position -300 to 300 0 Conditional*
Margin Position -99 to 99 0 Any
Cut Position -300 to 300
Note: The knife is not currently
supported for use with RFID
supplies.
0 0 only
Dispense Position 50 to 200 65 Conditional*
Backfeed Distance 10 to 200 65 Conditional*
Separators No/Yes/Long No Not recommended
Skip Index No/Yes No Not recommended
Knife Control -20 to 20 0 0 only
Error Action Normal
Overstrike/Continue 1x to 5x
Note: If using “overstrike,” do not
use Peel Mode.
Normal Conditional*
* Depends on the supply’s feed length. Refer to the RFID Setup Guide & Supply Chart for
the Supply and Print Position settings.
3-2 Multi-Protocol Application Notes