Instruction manual

3
SETTING UP THE PRINTER
Use this chapter to
♦ set the supply and print positions, if necessary
♦ set the Error Action for RFID labels
♦ view the Diagnostics version information.
Setting the Print and Supply Positions
Do not modify the Supply Position when using RFID supplies greater
than a two-inch feed length. Doing so may move the RFID tag out of
the RF Field’s readable and programmable range. If necessary, you can
modify the Print Position; however, make sure you do not move the tag
out of the readable and programmable range.
When using RFID supplies with a one-inch feed length, refer to the RFID
Setup Guide & Supply Chart for the Supply and Print Position settings.
(From the Main Menu, select Setup, Supply, Positioning, then select Print
Position and Supply Position.)
Using the Setup Supply Menu
MAIN MENU
Positioning
Feed Mode
Speed
Ribbon
Backfeed
Supply Type
Supply
Setup
Error Action
Skip Index
Separators
Backfeed
Distance
Knife
Control
Dispense
Position
Setting Up the Printer 3-1