Instruction manual

To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press  or  until you see
RFID
 Protocol
2. Press Enter/Pause. The current setting is displayed, for example:
PROTOCOL
C1Gen2 
3. Press  or  to change the protocol. After you display the option
you want, press Enter/Pause. When using the read-only EM4122
protocol, the settings for Write Power and Signal Adjust are ignored.
4. After you select a protocol, you are prompted to enter the Read
Power.
READ POWER
[1/25]: +14
5. Press  or  to increase or decrease the setting. After you display
the option you want, press Enter/Pause. Next, you are prompted to
enter the Write Power.
WRITE POWER
[14/25]: +14
Notice the value you entered for the Read Power is shown as the
lowest value available for the Write Power. (14 in the example
above.)
6. Press  or  to increase or decrease the setting. After you display
the option you want, press Enter/Pause. Next, you are prompted to
enter the Signal Adjust.
SIGNAL ADJUST
[0/6]: +2
7. Press  or  to increase or decrease the setting. After you display
the option you want, press Enter/Pause.
8. Press Escape/Clear until you see the Main Menu.
2-10 Multi-Protocol Application Notes