Instruction manual

Print Configuration Label
The RFID configuration label displays the module’s Firmware and
Hardware Versions, Module Type, Region, Frequency, all the Setup, RFID
Menu options, Good RFID Tags (number of RFID tags successfully
programmed since last cleared), and Bad RFID Tags (number of RFID
tags that failed programming since last cleared).
Depending on your application and volume of labels printed, you may
want to print this configuration label daily or after each batch.
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press  or  until you see
RFID
 Print Config
2. Press Enter/Pause. The configuration label prints.
You can also display the Firmware and Hardware Versions using
the Diagnostics Menu. See “Version Information
,” in Chapter 3
for more information.
The High Sensitivity module appears as Sirit-HS for the Module
Type or 93110841 (or greater) for the Hardware Version.
3. Press Escape/Clear until you see the Main Menu.
2-8 Multi-Protocol Application Notes