Instruction manual

Signal Adjust
Use the Signal Adjustment to increase the strength of the RF Field
emitted by the printer’s antenna. The higher the value, the greater the
power of the RF Field.
When using the read-only EM4122 protocol, the settings for Write Power
and Signal Adjust are ignored.
CAUTION: Use extreme caution when changing the Signal Adjustment
because the RFID tags may become non-functional!
To change the setting, from the Main Menu, select Setup, then RFID.
Then follow these steps.
1. Press  or  until you see
RFID
 Signal Adjust 
2. Press Enter/Pause. The current setting is displayed, for example:
SIGNAL ADJUST
[0/6]: +2
3. Press  or  to increase or decrease the setting. After you display
the option you want, press Enter/Pause.
4. Press Escape/Clear until you see the Main Menu.
Multi-Protocol Encoding 2-5