Instruction manual

6-8 Operator’s Handbook
No Image Errors
With version 5.2 or greater software, you can disable image error reporting.
Image errors occur when there is a problem producing a complete label.
You must press Escape/Clear to clear an image error.
Image errors include
600
unable to image batch
614
portion of field off label
601
problem during imaging
615
invalid PDF417 bar code data
603
missing batch
618
invalid font size
611
invalid font, bar code or density
620
missing font data
612
missing batch data
621
invalid downloaded font
613
reference point off label
622
not enough font memory
Note: With this option enabled, the format may not print as expected and
no error is reported. For example, bar codes require a non-print
zone and if a bar code is placed too close to the edge of the label,
no error is reported and the bar code may not scan properly.
Error 616 (bar code dot shifting failed) is always reported.
To change the setting, from the Main Menu, select Setup, then Defaults.
Then, follow these steps.
1. Press » or ¼ until you see
DEFAULTS
» No Image Error ¼
2. Press Enter/Pause. The current setting is displayed, for example:
NO IMAGE ERRORS
Disabled ¼
3. Press » or ¼ until you see the option you need. Then press
Enter/Pause.
4. Press Escape/Clear until you see the Main Menu.