Instruction manual

5-4 Operator’s Handbook
Flow Control
To change the setting, from the Main Menu select Setup, Port Settings, then
Serial Comm. Then, follow these steps.
1. Press » or ¼ until you see
SERIAL COMM
» Flow Control ¼
2. Press Enter/Pause. The current setting is displayed, for example:
FLOW CONTROL
» DTR ¼
3. Press » or ¼ to display the flow control you need, then press
Enter/Pause. Press Escape/Clear until you see the Main Menu.
XON is 17; XOFF is 19. Set flow control to DTR for PC computers
(unless you have XON/XOFF software).
Reset to Default Values
To change the setting, from the Main Menu select Setup, Port Settings, then
Serial Comm. Then, follow these steps.
1. Press ¼ until you see
SERIAL COMM
» Reset
2. Press Enter/Pause.
Are you sure?
No ¼
3. Press » or ¼ to make your selection, then press Enter/Pause. If you
select "Yes," the following defaults are restored: 9600 baud, No parity, 8
bit word length, and 1 stop bit. Press Escape/Clear until you see the
Main Menu.