Instruction manual

10-10 Operator’s Handbook
757
Load supplies (supply length mismatch), because the calibrated
supply length differs by plus or minus .25 inches from the format.
Press Feed/Cut.
758
Either the supply is not seen or the on-demand sensor is broken.
Check for a label jam, clear the supply path, or reload supplies. This
error may occur if you remove a label too quickly in the on-demand
mode.
763 Waiting to dispense label. Press Feed/Cut.
764
Verifier scan error (bad scan) on label when using normal (no
overstrike) mode. Press Escape/Clear to clear the error and continue
printing. The printer recalibrates (feeds a blank label) after this error.
765
The printhead has less than 8 bad dots. The printer can shift bar
code fields to avoid bad dots. You may need to press Escape/Clear
to continue printing. Print a test label to confirm the number of bad
dots.
768
Printhead has more than 8 bad dots within the format area or is not
connected. Connect the printhead.
772
Verifier scan error (bad scan) on label or multiple labels in a row
when using overstrike and continue mode. The verifier detected three
or more bad scans in a row. Press Escape/Clear to clear the error
and continue printing. The printer recalibrates (feeds a blank label)
after this error.
773
Verifier failure. The verifier is enabled, but not connected. Make sure
the I/O cable and/or serial cable is connected to the verifier. Refer to
your verifier's Operating Instructions for more information.
791
The printer has an error pending. Turn off the printer. Wait 15
seconds (until the power light is completely dim) and turn it back on.
Resend the packets.