Instruction manual

Diagnostics & Troubleshooting 10-9
611 Font, bar code, or density in the batch does not fit the format.
612
The data in this line of the batch is either missing or does not match
the format.
613 Reference point off supply.
614
Portion of field off supply or there may be an invalid character in the
packet.
703
The printer sensed a calibration of different-sized black marks. Make
sure the correct supply type is loaded.
704
Printer has not sensed a supply mark within the specified number of
inches or is out of supplies. Check the supply tracking, supply marks,
black mark sensor position, and supply roll for binding. Press
Escape/Clear and try to continue printing. Change supply.
750 Printhead is overheated. Turn off the printer.
751
Printer did not sense a black mark when expected. For errors 751-
753, check the supply tracking, supply marks, black mark sensor
position, and supply roll for binding. Press Escape/Clear and try to
continue printing. Change supply.
752 Printer sensed a mark in the wrong place.
753 Printer sensed a mark that is too long.
754
Check for a ribbon jam or remove any slack in the ribbon by turning
the take-up reel clockwise. Load a new ribbon.
755 Printhead is open. Close the printhead.
756 Load supplies.