Instruction manual
8-10 Packet Reference Manual
Data Formatting Failures
Formatting errors indicate that a field prints incorrectly. After you have checked the data
stream and corrected the data, retransmit the format and batch.
Note: For errors 571-622, the batch still prints, but the field, font, bar code, or density may
be incomplete, missing or contain incorrect data.
Error Description
Code
571 UPC or EAN bar code data length is invalid. The bar code data length in the batch
does not fit the format.
572 A copy field, padded field, or incrementing field length is invalid. The field length in
the batch does not fit the format or the field contains blanks. Or, the fixed length field
does not contain the specified number of characters.
573 Price field length is invalid. The price field length in the batch does not fit the format
or the field contains blanks.
574 No CD scheme or room for CD. The CD scheme in the batch does not fit the format or
the field contains blanks.
575 The graphic included in your format could not be found. Resend the graphic packet.
If the error persists, call Technical Support.
600 The printer could not image the batch, because the batch was refused. Call Technical
Support.
601 An error occurred while the batch was imaging. Resend the format, batch, font, and/or
any graphic packets. If the error persists, call Technical Support.
603 The batch was not found while imaging. Resend the batch packet. If the error
persists, call Technical Support.
611 Font, bar code or density is invalid. The font, bar code or density in the batch does
not fit the format.
612 The data in this line of the batch is either missing or does not match the format.
613 Reference point off tag.
614 Portion of field off tag. There may be an invalid character in the packet. Make sure
you did not enter O for 0 (zero).
615 Bar code width is greater than 16 inches or the number of keywords for your PDF 417
bar code exceeds 928. Decrease the density or shorten the amount of data to print
the bar code.
616 A bad dot falls on a bar code and the dot cannot be shifted. A gray box is printed
instead of the bar code.
618 Magnification must be 1 to 7 or 4 to 255 (point size) for the scalable font.
619 The JIS (16-bit) code for Kanji is invalid.
620 Font and printhead dot density mismatch