Instruction manual

5-2 System Administrator’s Guide
Creating a New Product Data File
You can use the Edit Utility to create a new data file.
1. Start the Edit Utility. The Main screen appears.
2. Click File, then New. A blank data file appears. To customize the data file, see “Editing the
Data File.”
Configuring the Network Settings
To communicate with the printer using Ethernet, enter your printer’s IP Address within the Edit
Utility. See “Adjusting the Network Settings” in Chapter 3 to view your printer’s IP Address.
Entering the Printer’s IP Address in the Edit Utility:
1. Connect the printer to your computer using an
Ethernet cable.
2. Turn on the printer.
3. Start the Edit Utility.
4. Click Setup, then Network.
5. Enter the printer’s IP address.
6. Click OK.
Specifying the Printer’s Type
The printer is available as a single printer (left printer only) or dual printer (left and right
printer). Specifying the correct printer’s type is important, so features display properly in the
Edit Utility.
1. Start the Edit Utility.
2. Click Setup, then Printer Type….
3. Select Single Printer or Dual Printer.
4. Click OK.
Enabling Alternate Button Names
The printer can display your product and category buttons in an alternate language. When you
enable alternate button names the language toggle button appears.
1. Start the Edit Utility.
2. Start a new data file or open your existing one.
3. Click Setup, then Alternate Button Names.
Note: To disable Alternate Button Names repeat
steps 1-3.