Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
93
Format Prefix
AP4.4 AP5.4 AP7.t
Indicates the start of a MLI format instruction.
xxH Default: xx = 5E (0x5E = „Caret“)
Delimiter Char
AP4.4 AP5.4 AP7.t
Used as a parameter place marker in MLI format instructions.
xxH Default: xx = 2C (0x2C = „Comma“)
Label Top
AP4.4 AP5.4 AP7.t
Label top offset (y-offet) in dots. Equals the parameter PRINT PARAMETERS >
Y-Printadjust
, which will be ignored, when MLI printjobs are printed.
xxx Dots Setting range: -240 - +240; Default: 0; Step width: 1
Left Position
AP4.4 AP5.4 AP7.t
Left position offset (x-offset) in dots. Equals the parameter PRINT PARAMETERS >
X-Printadjust
, which will be ignored, when MLI printjobs are printed.
xxx Dots Setting range: -9999 - +9999; Default: 0; Step width: 1
Manual Calibrate
AP4.4 AP5.4 AP7.t
For endless material, the label length information is sent in the printjob. For
punched material, the label length has to be detected by activating this func-
tion.
YES Label length calculation for punched material.
¯ Activate this function, if label material has changed.
¯ Calibration should be done after changing material, when there are no
printjobs loaded in the printer.
¯ Shortcut (in offline mode): press the feed + prog buttons simultaneously
to activate the calibration.