Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
90
Start rew. curr.
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Start rew. current  on page 86.
Start cur. len.
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Start cur. len.  on page 87.
Pullback current
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Pullback current  on page 87.
Back diameter
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Back diameter  on page 87.
Brake current
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Intern Rewinder“.
P See parameter Brake current  on page 88.