Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
88
Brake current
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Sets the brake current
P See parameter Pullback current  on page 87.
XXX Setting range: 0-100; Default setting: 0
Brake diameter
AP5.4
¯ Only in production mode.
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Sets the break diameter.
P See parameter Pullback current  on page 87.
XXX Setting range: 0-120; Default setting: 120