Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
82
¯ The Batch mode is optimised for printing and dispensing at high speeds.
Due to this, it is not possible to use all features awaliable in modes
Normal 1:1 or Real 1:1. Also consider, that printing data must be available on
time and in sufficient quantity.
¯ The following Job/Parameter-combinations must not be used:
y Jobs with counter fields
y Jobs with variable fields
y
SYSTEM PARAMETER > Dispensing mode must be set to "fast".
y The USI reprint function is not supported.
DP INTERFACE > Reprint signal must be
set to "deactivated".
y Foil save
P A graphic can be found under PRINT PARAMETERS > Cut mode > Batch mode.
Real 1:1 Mode (Default setting)
y The printer can print the whole label surface.
y After dispensing a label, the beginning of the next label is drawn back under
the print head.
y The output volume is lower than in Batch Mode or Normal 1:1 Mode.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Real 1:1 mode.
Dispenseposition
AP5.4
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Dispense position
Adjusts the dispense position in or against the feed direction. Depending on
the set dispense position, the dispensed label sticks to the backing paper with
a more or less wide strip (Fig. 11). The required width of this strip depends
on the further processing.
[16] Dispense position (= stopp position) of the dispensed label.
x.x mm Setting range: -30.0 to +20.0 mm; Unit interval: 0.1 mm; Default
setting: -6.0 mm
Dispensed label
Dispense position
Dispensing edge
Backing paper
Z0040E.cdr