Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
81
DISPENSER PARA
Dispense Mode
AP5.4
¯ Only if SYSTEM PARAMETER > Periph. device = „Dispenser“.
Governs the run of the print-dispense procedure.
¯ The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
Normal 1:1 Mode y The printer cannot print on the whole label surface. A stripe at the label
beginning stays unprinted.
y The label is being dispensed while printing.
y The output volume is at its maximum level.
¯ The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge (25mm) + Dispense position
P Also refer to parameter PRINT PARAMETERS > Dispense position.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Normal 1:1 mode.
[15] The size of the not imprintable area in Normal 1:1 depends of the setting of parameter
"SYSTEM PARAMETERS/ Dispense Position".
Batch Mode y The printer can print the whole label surface.
y Dispensing of the label takes place during printing. Printing of the next label
is interrupted until the label is completely dispensed.
y The output volume is at its maximum level.
a
b
c
Label
Backing paper
Printing
Printhead
Dispensing
Edge
Feed
Direction
Non-printable area with
Dispense
Dispense
a) Dispense position = 0
b) position < 0
c) position > 0
Z0137E.eps