Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

y REPRINT requests are processed after switching into online mode.

A "low" signal for 20 ms switches the printer into the pause mode. The pause

mode is the same as the "Online stopped" mode and can be switched to the

“Online” mode by pressing the feed button.

Error output

AP4.4 AP5.4 AP7.t

¯ Only with an I/O board mounted.

This parameter defines different events, which activate the output signal

ERROR.

Printer error ERROR will be activated in all of the following cases:

y Material end

y Ribbon end (only if

SYSTEM PARAMETER > Foil mode = „Thermo transfer“)

y No punch recognized (only if

PRINT PARAMETERS > Material type = „punched“)

y Printhead pressure lever was opened during the printing of a label.

y Start print error

y Other errors, which keep the printer from printing

¯ During the initialization (powering up) of the printer, the ERROR-signal is

instable!

Printererr + Offl In addition to the above mentioned cases avtivate the following events the

ERROR-signal:

y The printer is in offline mode

y The printhead pressure lever is open

y „I/O board pause“ mode

y Stopped mode (the printing was stopped)

Error Polarity

AP4.4 AP5.4 AP7.t

¯ Only with an I/O board mounted.

Switches the polarity of the ERROR signal.

Level high activ The output is high when it is active, otherwise low.

Level low active The output is low when it is active, otherwise high. (Default)