Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
78
Reprint Signal
AP4.4 AP5.4 AP7.t
¯ Only with an I/O board mounted.
Disabled The input signal is disabled
Enabled The last printed label will be reprinted on the falling edge of the REPRINT
signal.
Preconditions:
y The label to be reprinted, should be printed and dispensed.
y Printer is in online mode.
If a REPRINT is triggered while the printer is in “I/O-Board Pause” mode, the
reprint will proceed as soon as the printer is switched back in online mode. Precon-
dition: in level mode START PRINT must be inactive.
Feed input
AP4.4 AP5.4 AP7.t
¯ Only with an I/O board mounted.
Concerns the input signal FEED at the signal interface.
Enabled (Default setting) Feeding of one label on the falling signal edge. The display
shows „I/O board feed“ during feeding. Requirements are:
y Offline mode, „stopped mode“ or „pause mode“
y Online mode and no print job loaded.
Disabled Signals at the FEED input are ignored.
Pause input
AP4.4 AP5.4 AP7.t
¯ Only with an I/O board mounted.
Concerns the input signal PAUSE at the signal interface.
Disabled Signals at the PAUSE input are ignored.
Pause A high-to-low transition switches the printer into the “I/O-Board Pause” mode.
The next high-low-transition switches the printer back into the online mode. If
parameter
I/O-Board > Start print mode is set to „Level high active“ or „Level low
active“, any activating of the PAUSE signal stops the printing after the current
label.
Features:
y Printer display shows „I/O-Board pause“
y ERROR is active (only if
I/O Board > Error output is set to „Printer err+Offl“)
y If a print job is available: DATA READY becomes inactive (if
I/O Board >
Status output
is set to „Print job ready“)
y START PRINT signals are suppressed