Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
77
I/O BOARD
¯ This menu appears only if the optional I/O Board is mounted.
Start delay
AP4.4 AP5.4 AP7.t
¯ Only with an I/O board mounted.
Use this parameter to set the distance between product sensor (photoelectric
switch) and dispensing edge. The resulting delay time is calculated from the
start delay (distance) and the print speed, so it leads to a delay time t = start
delay (distance) / print speed.
xxx.xmm Setting range: 0.0 to 999.9 mm; Unit interval: 0.1 mm; Default setting: 0 mm
Start print mode
AP4.4 AP5.4 AP7.t
¯ Only with an I/O board mounted.
Selecting a print mode. Depending on the selected mode, the input signal
START_PRINT will be interpreted differently by the I/O Board signal inter-
face. The parameter is also used for the device connected to the foot switch
jack.
y Make sure to select
SYSTEM PARAMETER > External Signal = Single Start.
P See parameter External signal  on page 69.
y Note: The parameter
Start Print Mode replaces the parameter Signal Edge in the
SYSTEM PARAMETER menu.
y Preconditions: Print job is available (DATA READY), printer is in “Online”
mode, no error messages.
Pulse falling (Default setting) The printing of a label is triggered by a high-to-low change
of the signal at the input START PRINT. The printing occurs only after the set
delay time.
Pulse rising The printing of a label is triggered by a low-high change of the signal at the
input START PRINT. The printing occurs only after the set delay time.
Pulse fall/ris The printing of a label is triggered by a low-high-change as well as by a high-
low change of the signal at the input START PRINT. The printing occurs only
after the
set delay time.
Level low active Labels will be printed as long as the signal at input START PRINT is held low.
Level high active Labels will be printed as long as the signal at input START PRINT is held
high.