Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
71
Signal edge
AP5.4 AP7.t
¯ AP 5.4/AP 7.t: This parameter does not appear, if an I/O board is installed.
This parameter determins either the falling or the rising edge of an incoming
signal as trigger.
Falling edge The falling signal edge triggers a certain printer reaction.
Rising edge The rising signal edge triggers a certain printer reaction.
Print contrast
AP4.4 AP5.4 AP7.t
xxx% Setting range: 1 to 120%; Unit interval: 1; Default setting: 60
CAUTION!
The parameter
Print contrast affects directly the life durance of the printhead.
It counts: „The higher the setting of
Print contrast is, the lower is the life dur-
ance of the printhead“. This counts even more for settings above 100%.
Therefore mind:
« Always choose the lowest possible setting necessary to produce an accep-
table print result.