Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
70
Start mode
AP4.4 AP5.4 AP7.t
Settings for interpreting the start signal.
¯ Only relevant for start signals coming from the following sources:
– Foot switch connector (
SYSTEM PARAMETERS > Start source = „Foot switch“)
– D-Sub connector for dispensing edge light barrier (
SYSTEM PARAMETERS >
Start source
= „Light barrier“)
– not USI
P Detailed information about using start signals can be found in the user man-
ual, topic section „Advanced Applications“, chapter „Printing with start sig-
nal“, Settings in the parameter menu 
Level Labels of a certain print job are being printed as long as the signal level is
"high". When using a foot switch, labels are printed as long as somebody
keeps his/her foot on the foot switch.
Edge The rising / falling signal edge triggers the printing of exactly one label (De-
fault setting).
P See parameter Signal edge  on page 71.