Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
7
Operating the parameter menu
The illustrations on the following pages clarifie the operating principle of the
parameter menu. The return path shown on the left of the screen, called up
using the Prog. button, also applies for parameters in the middle of the
screen.
Setting values The setting of a parameter always follows this scheme:
1. Select the parameter.
2. Press the Online button.
3. Set the parameter to the intended value by pressing the Cut or Feed button.
4. Confirm by pressing the Online button.
Example
Setting the parameter PRINT PARAMETERS > Material type to punched material.
Action Display Note
OFFLINE 0 JOBS Initial state: off-line mode.
1.
Press Prog button. PRINT INFO
2.
Press Cut button. PRINT PARAMETERS
3.
Press Online button. PRINT PARAMETERS
Print speed
First menu item of the
"PRINT PARAMETERS"
menu.
4.
Press Cut button several
times, up to the display:
PRINT PARAMETERS
Material type
Parameter selected.
5.
Press Online button. Material type
Endless
6.
Press Feed button. Material type
Punched
Setting the parameter to
the intended value by
pressing the Cut or Feed
button.
7.
Press Online button. PRINT PARAMETERS
Material type
Confirm with Online but-
ton.
8.
Press Prog button 2x. OFFLINE 0 JOBS "Way back" by pressing
the Prog button.
Tab. 1:Example for setting a parameter: Changing the material type setting.