Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

Periph. device

AP4.4 AP5.4 AP7.t

After installation, options must be selected under "Peripheral device" in order

to be assured of the corresponding sensor queries and printer reactions.

¯ CAUTION! - Selecting an incorrect option can lead to malfunctions or

damage!

None No peripheral device is installed.

Cutter Sets the printer firmware to the cutter option. Selection permits access to the

cut parameters.

Rewinder Sets the printer firmware to the rewinder option. Selection permits access to

the rewinder setting parameters.

Tear-off edge Sets the printer firmware to the tear-off edge option. The punch is fed forward

to the tear-off edge.

Dispenser Setting for AP 5.4 dispenser version.

Intern Rewinder AP 5.4 only: Setting for printer operation in „internal rewinder“ mode, that is

operation with a deflector and without dispensing edge.

Tear-off + sensor AP 5.4 only: Setting for using the dispensing edge as tear-off edge. The

punch is fed forward to the dispensing edge.

TCS AP 7.t only: Textile Cutter-Stacker

Singlestartquant

AP4.4 AP5.4 AP7.t

Single start quantity

xx Setting range: 1 to 10; Unit interval: 1

External signal

AP4.4 AP5.4 AP7.t

The parameter determines, if and how an incoming signal at the - optional -

single start connector will be interpreted.

Disabled Signal interpretation disabled.

Singlestart The signal triggers the printing of a single label. This setting may be used e.g.

for printing single labels by means of a foot switch.

Stacker full The signal triggers the display of a status report and stops the printer. This

setting may be used when using a stacker (= stacker full signal).

P Detailed information about using start signals can be found in the user man-

ual, topic section „Advanced Applications“, chapter „Printing with start sig-

nal“, Settings in the parameter menu 