Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters

AP 4.4 – AP 5.4 – AP 7.t

Miss. label tol.

AP4.4 AP5.4 AP7.t

Missing label tolerance

The maximum search path for gaps which cannot be found can be varied. In

cases of difficult gap detection (i. e. minimum variation in the light transpar-

ency, gap to label), shortening the search path is to be recommended. Label

loss resulting from gaps not being detected can be reduced in this way. Print-

ing does not take place during the search process.

xx Setting range: 0 to 50; Unit interval: 1

y Example 0 (Zero label length): A gap must be found after a printed label

otherwise an error message is given. This setting is for detecting every

missing label.

y Example 5 (Five label lengths): A gap must be found after a maximum of 5

label lengths otherwise an error message is given.

Gap detect mode

AP4.4 AP5.4 AP7.t

After one of the following events, the printer must always search for the

punch, that is initialize the label material:

y After switching the printer on

y After changing the label material

Manual The operator has to initialize the material always manually by pressing the

feed key several times.

Autom. Forward (Default for printers) The material initialization is always done automatically,

if necessary. There is no backward movement of the material during the ini-

tialization.

Autom. feed back

¯ Only 64-xx Dispenser, ALX 92x, DPM/PEM

(Default for those devices) The material initialization is always done automat-

ically, if necessary. The label material is moved forward and backward during

the initialization. The stretch of backward movement can be set with param-

eter

SYSTEM PARAMETER > Max InitFeedback (see below).