Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
66
By pressing the cut button, the display can be toggled between error mes-
sage and Easy-Plug command text.
After acknowledging the first occured Easy-Plug error, the printjob and the
spooler are deleted (as by #!CA). This prevents the printing of labels with for-
mat errors.
Single job mode
AP4.4 AP5.4 AP7.t
In single job mode (also stop mode) the printer stops after every job and waits
until the operator restarts the print process.
Deactivated Single job mode is switched off (default setting).
Activated Single job mode is switched on. The printer always displays "Start next job",
before starting a new print job. This requests the user to acknowledge by
pressing the Online button.
Head resistance
AP4.4 AP5.4 AP7.t
For optimum print quality, the individual print head resistance of the thermo
head employed in the device must be set once with this parameter.
When replacing the print head, the resistance value of the print head (to be
read off from the print head) must be entered again.
¯CAUTION! - Entering a false value can damage the print head!
« Read off the correct value from the print head and set it accordingly.
¯ The value set here remains when the factory settings are carried out.
xxxx Ohm Setting range: 1000 to 1500 Ohm; Unit interval: 1 Ohm
Setting the print head resistance:
Setting:
1. From the print head, read off the resistance value to be set and make a note
of it (1000 to 1500).
2. In off-line mode press the Prog. button, display: PRINT INFO.
3. Press the Cut button until SYSTEM PARAMETER is displayed.
4. Press the Online button, display:
5. Press the Cut button until the following is displayed:
SYSTEM PARAMETER
Foil end warning
SYSTEM PARAMETER
Head resistance