Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
65
Feed mode
AP7.t
Head up (Default) The printhead is lifted during label material initialization and label
feeding.
Head down The printhead is down during label material initialization and label feeding.
Foil mode
AP4.4 AP5.4
Thermo transfer Thermo transfer printing (Ribbon sensor activated)
Thermal printing Thermo direct printing (Ribbon sensor deactivated)
Turn-on mode
AP4.4 AP5.4 AP7.t
Operating mode of the printer after it has been switched on.
Online Printer starts in on-line mode.
Offline Printer starts in off-line mode.
Standalone Printer starts in standalone mode.
Error reprint
AP4.4 AP5.4 AP7.t
If an error occurs while a label is printed, the last printed label will normally
be reprinted. In case of label layouts containing variable data like e.g. count
fields, switching off the reprint function possibly makes sense.
Enabled Reprint in error cases (default setting)
Disabled No reprint in error cases.
EasyPlug error
AP4.4 AP5.4 AP7.t
Handling of errors caused by faulty Easy-Plug commands.
Tolerant handl. The label is printed, after the Easy-Plug/Bitimage error was acknowledged
(default setting).
Strict handling The Easy-Plug command, which caused the error, is displayed after approx.
2 seconds in the lower display line. The displayed text is up to 30 characters
long and is scrolled automatically.
If a single character caused the error, this character is marked with „>> <<„
in the display text, to facilitate the detection.