Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
64
Sens. punch-LS
AP4.4 AP5.4 AP7.t
Sensitivity punch light sensor
Sets the sensitivity of the material photoelectric switch.
xxx% Setting range: 10 to 100%; Unit interval: 10%
Default setting: 50%
Maximum sensitivity: 100%. for narrow gaps (perforations).
Minimum sensitivity: 1%. for clearly detectable gaps.
¯ Too high a level of sensitivity can lead to gaps being detected which do
not even exist (on proofs, material thickness fluctuations, perforations etc.).
Ribbon autoecon.
AP7.t
Ribbon automatic economy mode
The ribbon feed can be interrupted during print periods with the ribbon auto-
matic economy parameter. This saves ribbon, particularly with long labels
with a minimum print area. The automatic function should only be activated
with unprinted areas from approx. 10 mm in length.
A selection can be made between thermal transfer printing and thermal direct
printing. It is necessary to select the type of printing in order to be able to
switch over the ribbon end detection.
Thermal printing Thermal direct printing (Ribbon-end-LS switched off)
Activated (not with AP 4.4/5.4)
Thermal transfer printing with ribbon automatic economy mode on.
Deactivated Thermal transfer printing with ribbon automatic economy mode off.