Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
63
Character filter
AP4.4 AP5.4 AP7.t
Character >= 20Hex Filter function is activated. Characters smaller than 20H are filtered out of the
data flow.
All character Filter function is deactivated. Characters smaller than 20H are treated as nor-
mal characters.
Light sens. type
AP4.4 AP5.4 AP7.t
Light sensor type
The optional reflex photoelectric switch for labels with reflecting length mark-
ings, or the normal factory-fitted photoelectric switch for labels with transpar-
ent or register gaps (self-adhesive labels), must be defined according to the
application.
Short label opt. (AP 5.4 only) Activates the optional short label sensor.
¯ Appears only in AP 5.4 printers which are equipped with the short label
sensor.
Full Size Full Size photoelectric switch (Adjustment range is the material width).
Reflex Reflex photoelectric switch (for reflecting markings)
Punched Transparent photoelectric switch (for gaps)
Head-sensor dist.
AP4.4 AP5.4 AP7.t
¯ Parameter appears only in production mode or if a value > 0 is set.
Printhead-sensor distance
Special function for setting non-standard punch sensors. Such sensors can
be applied in special application devices ("Nistan"). The value x is the dis-
tance between thermal edge and punch sensor in millimeters.
x mm Setting range: 0 to 400 mm
¯ A „non standard sensor“ must be installed and connected instead of the
regular punch sensor.
¯ 0 = disabled (the regular punch sensor is used).