Service manual

09/09 Rev. 5.03-01 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 4.4 – AP 5.4 – AP 7.t
60
SYSTEM PARAMETERS
Foil end warning
AP4.4 AP5.4 AP7.t
Setting of a limit diameter for the ribbon roll. If the ribbon roll diameter falls
below the set value, the displayed message changes from…
64-xx, DPM / PEM, ALX 92x:
Additionally to the display message, a signal is set at the (optional) USI.
P For details refer to the parameters DP INTERFACE > Ribbon signal and
SERVICE DATA > OPERATION DATA > Foil diameter
x.xx mm Setting range: 25.4 to 50.0 mm; Unit interval: 0.1 mm;
Default setting: 25.4 mm
Foil warn stop
AP4.4 AP5.4 AP7.t
Disabled (Default setting) Printer does not stop in case of a „Foil end warning“.
Enabled If a „Foil end warning“ occurs, the printer stops after the current label and
shows the status message:
« Press the online button to acknowledge the message, then the feed button to
continue printing.
ONLINE X JOBS …to…
FOLIE X JOBS …while the display is blinking.
PrintStatus: 5110
Foil low